Contact KTI. Have a Question? KTI Hydraulics, Inc. This will help preserve the new condition of the remote control and prevent theft. Remove the four-button pendant from the power unit at the quick disconnect. Torque fittings to 18 lb. Connect hydraulic hoses to two cylinders applications may vary. Connect the Positive cable from the battery to the start solenoid diagram A Please see BatteryCable recommendation for proper cable length to use for your hydraulic power unit.
Use a wrench to hold the bottom nut in place, to torque the upper nut to 3 ft. Reconnect the four-button remote pendant at the quick disconnect. After the cylinder is fully extended, press the IN button to fully retract the cylinder. Remove the two-button pendant from the power unit at the quick disconnect. Connect the Positive cable from the battery to the start solenoid diagram A Please see Battery Cable recommendation for proper cable length to use for your hydraulic power unit.
Use a wrench to hold the bottom nut in place, to torque the upper nut to 3 ft. Reconnect the two-button remote pendant at the quick disconnect. Operate the power unit while keeping an eye on the fluid level in the reservoir. When running your hydraulic power unit for the first time, do not allow the fluid to drop below the half full level, while raising or extending the hydraulic cylinder. This will cause the power unit to induce air into the system.
During activation of the down function, the air in the system will cause aeration of the fluid and overflow the reservoir tank. Refer to the Bleed Cycle Procedure Instructions to purge air from the hydraulic system. Fluid level should be approximately 1 inch from the top of the reservoir. Diagram A There could be an incentive in it for you Installation Videos Videos so detailed you can have your kids do it! No matching collections.
Invalid Password. Product has been added to your wishlist.
0コメント